Calibration of parallel gauges, plug gauges, rings …

Tradelab performs calibration of parallel gauges, plug and ring gauges with ENAC (ILAC) accreditation.

Typology of these parallel gauges:

Screw plug gauges.
Screw ring gauges.
Plain plug gauges
Plain ring gauges
Plain gap gauges
Plain setting rings

Calibración ENAC

Parallel screw plug gauges, with symmetric thread and low helix angle <5º, up to 200 mm and pitch ≥ 0,25 mm in permanent laboratory.
Parallel screw ring gauges, with symmetric thread and low helix angle <5º, from M1,6 mm to 200 mm and pitch ≥ 0,25 mm in permanent laboratory.
Parallel screw plug gauges, with symmetric thread and low helix angle <5º, up to 150 mm and pitch ≥ 0,25 mm on site.
Parallel screw ring gauges, with symmetric thread and low helix angle <5º, from M2 mm to 100 mm and pitch ≥ 0,25 mm on site.
Plain plug gauges up to 200 mm y Plain ring gauges up to 250 mm in permanent laboratory and on-site.
Plain gap gauges up to 200 mm in permanent laboratory and on site.
For more information refer to the calibration annex:

Technical Accreditation Annex

Information required to perform a calibration budget

Indicate type and class gauge.
Indicate designation.

Request a quotation

Tradelab is the only laboratory in Spain with ENAC (ILAC) accreditation to perform on-site calibration of parallel screw and plain gauges (plugs and rings).

Tradelab is also the only laboratory in Spain that performs calibration of parallel screw ring gauges from M 1,6 mm with ENAC (ILAC) accreditation.

In addition to the calibration of these gauges, Tradelab offers calibration of other measuring instruments.